replacing totted tongue and groove porch flooring

replacing tongue and groove porch boards - DoItYourself.com,Jul 14, 2008 ... replacing tongue and groove porch boards ... of the three steps up to it, about 24 boards (of I bet the 120 on the porch) are rotted about a foot in.

How to Repair Tongue and Groove Porch Flooring | DoItYourself.com,When you are working with tongue and groove porch flooring, there are things ... Once you have cut and adjusted the replacement plank, you will run wood glue...

Repair for an Old Wooden Porch - Extreme How To,I decided to replace the entire side of porch flooring with the exception of a roughly ... In order to repair my porch I needed to use tongue-and-groove (T&G) lumber. ... Although the wood columns and the boards beneath them had rotted, the...

How to Replace a Rotten Wood Porch Floor | Today's Homeowner,Mar 27, 2015 ... Watch this video to find out how to remove a rotten wood porch floor, and replace it ... Here the ledger board that supported one of the joists has rotted and ... The trick to installing a tongue and groove porch floor is getting the...

Tongue Groove Porch Fix or Rebuild? | This Old House,Mar 19, 2013 ... ... of the porch is about 12 foot by 12 foot..a few the boards have rotted ... be to replace the whole porch in a similar tongue and groove flooring?

Front Porch Fix-up | This Old House,How to replace weathered, rotting outdoor flooring. ... Replacing porch decking is not a challenging task for any homeowner who's used a circular .... exposed joists, then place the groove of a replacement board over the tongue of an old deck...

PORCH FLOORING REPAIR,... your porch landing feels spongy, or if a few of the flooring boards have rotted ... It's not always necessary to replace the whole floor; you can often get away ... edges of flooring are called “tongue” and. “groove.” These ends are made to work.

How to Fix a Rotten Wood Porch Floor | Home Guides | SF Gate,Working out the strategy for repairing a rotted porch floor is less difficult than ... If you're replacing tongue-and-groove boards, you have to cut the bottoms of the...