should spacers be used behind ledger board and house

What is the proper way to flash a deck ledger? - GreenBuildingAdvisor,May 23, 2012 ... How can I attach a ledger to an outside brick wall for a deck? ... stack of washers as a spacer, or you can use alternatives such as Deck-2-Wall Spacers ... To ensure that the wall behind the ledger is watertight, I apply a strip of...

Dear Glenn: One Builder's Headache With Deck Ledger Codes,Nov 13, 2015 ... You seem to be the go-to guy when it comes to deck construction. .... and they specified metal ā€œZā€ flashings above the ledger and behind the siding. ... recommendations (and graphics) are used to develop the IRC code. ... or Deck-to-Wall spacers, providing an air gap so ledgers can dry out and prevent rot.

Deck Ledgers | Best Practices Manual | Hammer & Hand | Pacific,This section of Hammer & Hand's Best Practices Manual details deck ledgers. ... Make sure pilot holes are slightly smaller than the lag (if bolts are not being used). Note: Ledger can be temporarily tacked in place to pre-drill through ledger and rim ... Deck Ledgers Detail 6 Center Spacers Over Bolt Holes | Hammer & Hand.

Deck2Wall Spacer Black Polypropylene Spacer 2-1/2 ... -,GCP Applied Technologies Vycor Plus 4 in. x 75 ft. .... Gap Deck Board Spacer for Hidden Deck Fasteners (6-Count) · (2) .... It should be.. your competition has it.

ledger board spacers - YouTube,Apr 28, 2017 ... ledger board spacers. ... How to Cut and Install Fiber-Cement Siding - This Old House - Duration: 5:06. This Old House 829,269 views · 5:06.

Decks.com. Deck Ledger Spacers,Learn how to install deck ledger board spacers to allow air to flow behind your ... Multiple stainless steel washers can be used or a variety of engineered ... drilled you can remove the ledger board and attach the spacers to the house side of the...

Modern Deck Building | Construction Pro Tips,Nov 16, 2017 ... These yellow deck board spacers can be used to space boards either 1/8 in. ... by water finding its way behind the ledger and into your home.

Keeping Water Out of Decks | Professional Deck Builder,Protecting a house against water intrusion starts with creating a barrier, such as siding, ... Otherwise, water will get behind the ledger board and cause damage to the ... However, it doesn't take paint well and should be used cautiously near areas ... is to space the joists apart with pressure-treated plywood spacers (Figure 3).

Decks.com. Ledger board installation attachment and flashing,You should flash your ledger before you install your decking. Over time the house frame behind the deck will rot if it gets wet. ... Deck Ledger Spacers. Learn how...

How to Attach a Deck Ledger to the House - Fine Homebuilding,Dec 10, 2010 ... If it's flashed properly you won't have to worry about spacers.ā€ Flashing, of course, is key. Any water trapped behind the ledger can induce rot, if not in the ledger ... (at house and at edge of deck) then no ledger should be used.